Skip to content
Halton Door SpecialistsRequest a visit
Open 24/7(289) 815-6458Call now
Gloved person holding a black strip along the side of a sectional garage-door opening — Garage Door Perimeter Weatherstrip, Sunningdale

Plan ahead Repairs · Sunningdale

Garage Door Perimeter Weatherstrip in Sunningdale

Every time the door closes there is a rubbing squeal along one side, and the flexible fin has folded under itself and torn. Someone painted the trim last summer and painted the seal with it; now it is stiff as a board.

Call now · open 24/7(289) 815-6458

Request a visit

In plain words

Winter is what wears a perimeter seal out here. Sun and cold cycles harden the vinyl until it cracks, freezing rain glues the fin to the door so the opener tears it, and salty slush sits against the bottom of the jambs and rots the wood the strip is nailed to. One visit deals with all of that: soft wood at the base of the jamb is cut out and replaced, fresh seal is fitted in continuous lengths with the corners overlapped, and the fin is wiped with silicone so ice does not bond to it. The garage stays drier and calmer through the next freeze-thaw season.

Sound familiar?

The bedroom over the garage is always the cold room, and standing in the garage you can feel why: a steady draft along the door edges that moves the cobwebs on the wall. The seal around the opening has flattened to nothing.

How the visit goes

Garage Door Perimeter Weatherstrip · Sunningdale

How the visit goes

Technician in gray gloves holding a red-handled tool at a black roller on the curved door track, under a white door panel. — Sunningdale
  1. 1

    How the door sits in the opening

    A perimeter seal can only follow a door that sits where the frame expects it, so the door is checked before any strip is ordered or cut. Each edge is checked for plumb, the gap to both jambs is compared, and the top section is watched as it meets the header to see whether it bows away or leans in. Rollers, hinges and the spacing of the vertical tracks are looked at because any of them can shift the door face toward one jamb and away from the other. Small corrections, such as re-setting a track bracket, are noted so the new seal is fitted to a door that closes square and stays that way.

  2. 2

    The header piece goes on first

    With the door closed, the header length is cut to the full width of the opening and lifted into place, a two-person job on a double door. It is positioned so its fin lies against the top section with a slight, even deflection along the whole width, then fastened from the centre outward with galvanized or stainless nails or exterior screws at regular spacing, which keeps the length straight rather than letting it wander. The ends are left to receive the side pieces beneath them. Fitting the header first means both sides are cut to meet it exactly, and the corners close properly.

  3. 3

    A note of what was fitted

    Before leaving, the technician tells you what went on: the seal type, the profile and fin width, the colour, and the lengths of the header and sides. It is worth writing this on a card near the opener or in the door's paperwork. If one length is ever damaged, by a ladder or a car mirror, the same profile can be matched and a single piece replaced rather than the whole set. If a jamb was repaired, the note records where and with what, so anyone painting or working on the frame later knows what is behind the finish.

In the van

  • Galvanized or stainless trim nails
  • Vinyl stop moulding with integral seal
  • Tape measure, level and square
  • Jamb repair lumber or PVC trim
  • Epoxy consolidant and exterior primer

What affects the quote

  1. 1

    Jamb material

    Wood jambs take nails; steel or aluminum-clad jambs need screws and sometimes a backing piece, and masonry openings need a different fixing altogether, each with its own time and hardware.

  2. 2

    Alignment work on the door

    Where the door sits out of square and a track bracket or the door itself needs small correction before the seal can meet it evenly, that adjustment is named separately.

  3. 3

    Adding a brush or foam seal to the sides as well as the stop

    Some households want only the top and side stop replaced, while others add a brush or foam seal along the same run for a tighter fit against wind-driven snow. That extra material and the time to fit it are agreed before the old stop comes off.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(289) 815-6458

Garage Door Perimeter Weatherstrip: questions

Advice · (289) 815-6458

How should I look after the new seal?

Four times a year, check for daylight from inside with the lights off and press the fin to feel that it is still soft. Wipe the seal with a damp cloth to clear grit and salt, keep paint off the fin, apply a silicone wipe before winter, and keep slush and bins away from the bottom of the jambs. Press any lifted corner back and call if a length has come loose.

What is the difference between perimeter weatherstrip and the bottom seal?

The bottom seal is a rubber or vinyl strip fixed to the lower edge of the door itself and presses against the floor. Perimeter weatherstrip is fixed to the frame, running up both jambs and across the header, and the closed door presses against it from inside. They wear differently and are replaced separately, though it is common to renew both in one visit when each is showing its age.

Does it matter if my garage is detached and unheated?

The seal still earns its place. It keeps driven snow, rain, leaves and animals out of the garage and off whatever is stored there, and it stops the door edges rattling in the wind. For an attached or heated garage the comfort benefit to the house is added on top. The technician may suggest a simpler fin replacement for a detached shell and a one-piece stop where the garage is lived beside.

Garage Door Perimeter Weatherstrip near you

Halton, Ontario

Sunningdale information

Town
Sunningdale, Halton, Ontario
In business
21 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

27%

Newer homes. About 27% of homes in Oakville were built in 1980 or earlier, according to the 2021 Census.

Many newer homes have a keypad by the door, several remotes and an app that reports whether the door is open. We keep all of these talking to the opener, clear codes from devices that have gone missing and set up new ones so the whole household is covered.

59%

A mix of homes. Single-detached houses make up about 59% of homes in Oakville (2021 Census).

A blend of housing means a blend of garages: spacious attached garages with full headroom on the detached lots, and tight tandem garages with little side room in the attached units. Openers, tracks and springs are all sized at the door rather than assumed from the street.

Source: Statistics Canada, 2021 Census of Population

Open Sunningdale in Google Maps

Open 24/7

Request a visit

Every time the door closes there is a rubbing squeal along one side, and the flexible fin has folded under itself and torn.

Call now · open 24/7(289) 815-6458
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 21 years in business